MILK TEXTURING TIPS

23 January 2019
Category: Tips

There’s no doubt about it, milk texturing takes a fair bit of practice. Mind you, there’s no point in having fabulous milk if you have a terrible espresso pour so they are both key factors in ensuring a delicious coffee! Here are some important tips on getting silky, creamy milk every time:

PREPARATION:

  1. Cups: should be warm. If not, preheat with hot water first.
  2. Jugs: should be stainless steel, and kept cold.
  3. Milk: for the best results, milk should be cold rather than reheating warm or hot  milk.
  4. Remember the milk expands only in the first stages of heating (up to 40°).
  • Choose the right jug size. A smaller jug, to suit 2 cups is quick and reduces the likelihood of having leftover heated milk.
  • Pour fresh cold milk into the stainless steel jug. Fill the jug to no more than half full (and a minimum of 200ml), to allow expansion of the foamed milk.
  • Position the tip of the steam nozzle, just below the surface of the milk at the side of the jug (and not touching).
  • Tilt the jug to one side at about a 45° angle. This will result in a whirlpool motion of the milk. When adding the steam the noise you will hear is a quiet ‘ssst, ssst, ssst.’ If the tip of the nozzle is too far below the surface of the milk, you will hear a ‘howling’ sound, or a ‘screeching’ sound if the wand touches the side of the jug.
  • When the milk begins expanding and you have some foam, slowly move the jug down so that the air is drawn into the milk. Add steam only in small amounts to create tiny bubbles and velvety foam. As the volume of your milk and foam increases, hold the jug upright and continue to heat the milk with the wand just off the bottom of the jug, tapping the side of the jug as you go, to feel the heat increasing (don’t use the base of the jug to test the temperature as the base is heavier and will give you a false reading).
  • If using a thermometer, heat until you reach 60° then quickly turn off the steam. The thermometer will then rise a further 5° once the steam is turned off. 65°-70° is the ideal temperature to serve. Over 70° is heading for over heated, boiled milk.
  • The foam should be dense with fine bubbles. Swirl and tap the base of the jug on the bench to collapse any large bubbles within the bulk of the milk. Immediately clean the steam nozzle with a clean damp cloth and purge to release any milk sucked up the nozzle.
  • Slowly pour the silky smooth, foamed milk into the centre of the espresso shot. This will form a marbleisation of milk foam, creamy milk and espresso coffee. Always pour the frothy coffees first (cappuccino, lattes, hot chocolates, mochas)
  • Do not reheat large amounts of leftover milk. It not only tastes awful but can also be a health hazard. Only very small amounts can be reheated, when topped up with fresh cold milk.

FACT: The higher the fat content of the milk – the creamier the froth with be. Low fat milk makes fluffy, airy foam; position your steam wand deeper in the milk to reduce aeration. Soy milk also produces thick, fluffy foam, and should not be heated beyond 55 °C to prevent curdling.